Do not bother to try to cut the chamber and extractor at the same time by clamping the two together. You will make that mistake JUST ONCE in your life as well. File the barrel, NOT THE EXTRACTOR! You can set the barrel back if you screw up but finding a new extractor is next to impossible and they are a bitch to make. Screw the barrel back on to the receiver and check for extractor fit with layout fluid and file if necessary. I use a woodruff key cutter but the barrel can be inverted and the cut made with an endmill.įinally, figure C, reposition and level the barrel in the vise to 12 degrees and slab off the rest of the extractor cut with a woodruff cutter or endmill. Proceed to figure B and level and square the barrel in the mill vice and slab off to establish the 90 degree cut for the top of the extractor. This will allow you to level the barrel to make the extractor cut. With the barrel in a vise level the receiver and then clamp a machinist clamp on the barrel and level the clamp to the side of the receiver. YOU WILL FORGET THIS STEP ONCE IN YOUR LIFE! Witness mark the barrel and receiver at this point. 650 but a ring should be there.Īfter figure A is complete the barrel must be screwed on to the receiver tightly with an action wrench and the threads worked several times to remove all crush otherwise the barrel will screw over center when you are taking it on and off to final fit the extractor. 650 inch ring on the face is important as it will later be used to find center.
![bsa martini cadet bsa martini cadet](http://media.liveauctiongroup.net/i/36579/31637970_2.jpg)
![bsa martini cadet bsa martini cadet](http://www.deactivated-guns.co.uk/images/uploads/22martini1911/22martini1911-057651.jpg)
The barrel extension and threads must first be cut and threads must be to a class 4 fit. The Martini can be a real pain in the ass to barrel if certain steps are not followed.
#Bsa martini cadet software
Sorry, not me it's the software saving storage space.īSA Martini Cadet *** 14 TPI 60 degree V thread. The forum software reforms the JPGs and makes them to small to read. OK I had to do some scronching and squitching to make all this work and I will post the text separately here.